Filter
Top Products
Note
The SteadyShot function may not work optimally when the power has just been
turned on, right after you point the camera towards a subject, or when the
shutter button has been pressed all the way down without stopping halfway.
When using a tripod, make sure to turn off the SteadyShot function because
this can cause any malfunction when shooting.
[SteadyShot Settings] will be unavailable when MENU → (Camera
Settings) → [SteadyShot] is set to [Off].
When the camera cannot obtain focal length information from the lens, the
SteadyShot function does not work correctly. Set [SteadyShot Adjust.] to
[Manual] and set [SteadyS. Focal Len.] to match the lens you are using. The
current set value of the SteadyShot focal length will display to the side of
.
When using an SEL16F28 lens (sold separately) with a teleconverter, etc., set
[SteadyShot Adjust.] to [Manual] and set the focal length.
When you turn [SteadyShot] [On]/[Off], the in-body/in-lens SteadyShot settings
switch at the same time.
If a lens equipped with a SteadyShot switch is attached, the settings can only
be changed using that switch on the lens. You cannot switch the settings using
the camera.
[161] How to Use Using shooting functions Setting the other functions of this product
Long Exposure NR (still image)
When you set the shutter speed to 1 second(s) or longer (long exposure
shooting), noise reduction is turned on for the duration that the shutter is open.
With the function turned on, the grainy noise typical of long exposures is reduced.
1. MENU → (Camera Settings) → [ Long Exposure NR] → desired
setting.