Filter
Top Products
UB Preset:
Sets the user bit.
TC Format:
Sets the recording method for the time code.
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
1. MENU → (Setup) → [TC/UB Settings] → [TC Preset], then press in
the center of the control wheel.
2. Turn the control wheel and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
*
When [24p] is selected, you can select the last two digits of the time code
in multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
3. Set the other digits following the same procedure as in step 2, then press
in the center of the control wheel.
How to reset the time code
1. MENU → (Setup) → [TC/UB Settings] →[TC Preset], then press in
the center of the control wheel.
2. Press the (Delete) button to reset the time code (00:00:00:00).
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote
commander (sold separately).
How to set the user bit (UB Preset)
1. MENU → (Setup) → [TC/UB Settings] → [UB Preset], then press in
the center of the control wheel.
2. Turn the control wheel and select the first two digits.
3. Set the other digits following the same procedure as in step 2, then press