Filter
Top Products
in the center of the control wheel.
How to reset the user bit
1. MENU → (Setup) → [TC/UB Settings] → [UB Preset], then press in
the center of the control wheel.
2. Press the (Delete) button to reset the user bit (00 00 00 00).
How to select the recording method for the time code (TC Format)
1. MENU → (Setup) → [TC/UB Settings] → [TC Format], then press in
the center of the control wheel.
DF:
Records the time code in Drop Frame* format.
NDF:
Records the time code in Non-Drop Frame format.
*
The time code is based on 30 frames per second. However, a gap between the actual time
and the time code will occur during extended periods of recording as the frame frequency of
the NTSC image signal is approximately 29.97 frames per second. Drop frame corrects this
gap to make the time code and actual time equal. In drop frame, the first 2 frame numbers
are removed every minute except for every tenth minute. The time code without this
correction is called non-drop frame.
The setting is fixed to [NDF] when recording in 4K/24p, 1080/24p or 1080/25p.
How to select the count up format for the time code (TC Run)
1. MENU → (Setup) → [TC/UB Settings] → [TC Run], then press in
the center of the control wheel.
Rec Run:
Sets the stepping mode for the time code to advance only while recording. The
time code is recorded sequentially from the last time code of the previous
recording.
Free Run:
Sets the stepping mode for the time code to advance anytime, regardless of the
camera operation.
The time code may not be recorded sequentially in the following situations even
when the time code advances in [Rec Run] mode.
When the recording format is changed.
When the recording medium is removed.