Filter
Top Products
How to select how the time code is recorded (TC Make)
1. MENU → (Setup) → [TC/UB Settings] → [TC Make], then press in
the center of the control wheel.
Preset:
Records the newly set time code on the recording medium.
Regenerate:
Reads the last time code for the previous recording from the recording medium
and records the new time code consecutively from the last time code. The time
code advances in [Rec Run] mode regardless of the [TC Run] setting.
[214] How to Use Changing settings Setup menu
Remote Ctrl
You can shoot images using the RMT-DSLR1 or RMT-DSLR2 remote
commanders (sold separately). Refer also to the operating instructions for the
remote commander.
1. MENU → (Setup) → [Remote Ctrl] → desired setting.
Menu item details
On:
Allows remote commander operation.
Off:
Does not allow remote commander operation.
Note
The RMT-DSLR1 remote commander cannot be used for movie recording.
The lens or lens hood may block the remote sensor that receive the signals.
Use the remote commander in the position from which the signal can reach the
product.
When [Remote Ctrl] is set to [On], the product does not switch to power save
mode. Set [Remote Ctrl] to [Off] after using a remote commander.