Filter
Top Products
If any filter or hood is used, take it off and try shooting again. Depending on the
thickness of the filter and improper attachment of the hood, the filter or the
hood may partially appear in the image. The optical properties of some lenses
may cause the periphery of the image to appear too dark (insufficient light).
You may compensate for this phenomenon with [Shading Comp.].
When using an E-mount lens for APS-C size shooting, set [APS-C/Super
35mm] to [Auto] or [On], then shoot the images.
[337] Troubleshooting Troubleshooting Shooting still images/movies
The image is blurred.
Make sure that [SteadyShot] is set to [On].
The picture was taken in a dark location without the flash, resulting in camera-
shake. The use of a tripod or the flash is recommended. [Hand-held Twilight]
and [Anti Motion Blur] in [Scene Selection] are also effective in reducing blur.
If you are using [SteadyShot Adjust.] set to [Manual], check if the right focal-
length is set.
[338] Troubleshooting Troubleshooting Shooting still images/movies
The monitor darkens after a short period of time passed.
If you do not operate the product for a certain period of time, the product
switches to the power-save mode. The product exits power-save mode when
you perform operations such as pressing the shutter button halfway.
[339] Troubleshooting Troubleshooting Shooting still images/movies
The flash takes too long to recharge.
The flash has been fired in succession in a short period. When the flash has