Filter
Top Products
Troubleshooting Guide
472
If the power is turned off while an image is being recorded to the card, the
access lamp will remain on or continue to blink for a few seconds. When
the image recording is completed, the power will turn off automatically.
Do not use any battery other than a genuine Battery Pack LP-E6N/LP-E6.
Remove and install the battery again (p.42).
If the battery contacts are dirty, use a soft cloth to clean them.
Use a fully-charged battery (p.40).
The battery performance may have degraded. See [53: Battery info.]
to check the battery’s recharge performance level (p.446). If the
battery performance is poor, replace the battery with a new one.
The number of possible shots will decrease with any of the following
operations:
• Pressing the shutter button halfway for a prolonged period.
• Activating the AF frequently without taking a picture.
• Using the lens’s Image Stabilizer.
• Using the LCD monitor frequently.
• Continuing Live View shooting or movie shooting for a prolonged period.
• The Eye-Fi card’s communication function is operating.
Auto power off is in effect. If you do not want auto power off to take
effect, set [52: Auto power off] to [Disable] (p.69).
Even if [52: Auto power off] is set to [Disable], the LCD monitor will
still turn off after the camera is left idle for 30 min. (The camera’s
power does not turn off.)
The access lamp still lights or blinks
even when the power switch is <2>.
[Does this battery/do these batteries display the Canon logo?]
is displayed.
The battery becomes exhausted quickly.
The camera turns off by itself.