Filter
Top Products
225
When you switch the power to <1> or <2> (or Camera auto off),
the Self Cleaning Sensor Unit will operate automatically to remove dust
on the image sensor. Normally, you need not pay attention to this
operation. You can also activate or stop the Self Cleaning Sensor Unit
when necessary.
1
Select [Sensor cleaning].
Under the [53] tab, select [Sensor
cleaning], then press <Q/0>.
2
Select [Clean nowf].
Select [Clean nowf], then press
<Q/0>.
On the dialog screen, select [OK] and
press <Q/0>.
X The screen will indicate that the
sensor is being cleaned. Although
there will be a shutter sound, a
picture is not taken.
X The sensor cleaning also works while
no lens is attached. If no lens is
attached, do not insert your finger or
blower tip beyond the lens mount.
This is to prevent damage to the
shutter curtains.
The camera will restart.
f Automatic Sensor Cleaning
Cleaning the Sensor Now
For best results, perform the sensor cleaning with the camera placed
upright and stable on a table or other flat surface.
Even if you repeat the sensor cleaning, the result will not improve much.
Immediately after the sensor cleaning is finished, the [Clean now
f]
option will remain disabled temporarily.
COPY