Filter
Top Products
2-9
Setting Up
5. A setup progress window appears and
your settings will be saved.
Note
● Set the IP address to a value that suits your environment.
● Where the IP address has been automatically obtained from the DHCP server, you
cannot change the IP address setting from the VB Initial Setup Tool. If you wish to
change the IP address, change it from the Network Settings page (→ P.3-6).
● Please consult with your network administrator for the IP address, subnet mask
and default gateway address settings.
●
If 20 minutes or more passes after the VB-C50i/VB-C50iR is turned on, the VB-C50i/
VB-C50iR stops sending requests for IP addresses allocation and they cannot be
detected using this tool. If this occurs, restart the VB-C50i/VB-C50iR.
● To restore the factory default settings, refer to page 7-23.
●
If you are using the Multi-Terminal Module and are changing the connection of the
VB-C50i/VB-C50iR and external camera, be sure to do this after having turned off
the power of these 2 devices. After changing the connection, turn on the external
camera first and then the VB-C50i/VB-C50iR.
3. Perform Initial Settings for the Camera
Initial settings are now complete.