Filter
Top Products
3-7
Basic Settings
You can perform the following settings with Camera and Video.
●Video Capture: For setting image size and quality.
●Camera Control: For setting the camera shutter speed, focus, home position and
view restrictions.
●Camera Names: Enter camera names. A camera name is required when you use
an external camera or the VK-64.
When you have made changes to the settings, click the “OK” button to return to the
Settings Title Page. If you do not make any changes, click the “Cancel” button.
Setting Camera Control, Image Size and Quality (Camera and Video)
Video Capture
1 “Video Capture Size”
Select an image size for “Video Transmission”, “Motion Detection” and “Picture Recording”.
For “Motion Detection”, select either “Medium Size” or “Small Size” as the image size.
*Please refer to P.1-10 to confirm whether your VB-C50i/VB-C50iR is PAL model or NTSC model.
Large Size: 640 × 480 (NTSC), 768 × 576 (PAL)
Medium Size: 320 × 240 (NTSC), 384 × 288 (PAL)
Small Size: 160 × 120 (NTSC), 192 × 144 (PAL)
2 “Video Quality (Q-Factor)”
Select a value from 10-100 (in 10 levels). The greater the value, the better the quality. However,
since data size will also be larger, higher-quality pictures may lower the frame rate. Also, if you
select “Not used”, you cannot set that size in “Video Capture Size”.
3 “Interlace Mode”
Select either “Weave (Interlace)” (for subjects which move a little) or “Bob (Non-Interlace)” (for
subjects which move a lot), according to the range of the movement.
You can obtain high-resolution video if you set “Video Capture Size” to “Large Size”. However
1
2
3
4