Filter
Top Products
3-9
Basic Settings
Tip
The operating range of the camera heads on the VB-C50i/VB-C50iR is shown below.
Note
Do not attempt to manually change the camera head angle.
If the camera head is accidentally moved by hand or other objects
touching it, be sure to restart the VB-C50i/VB-C50iR by turning
the power supply OFF then ON again.
4 “Apply View Restriction”
If you check the “Apply View Restriction” option, the settings below are enabled. Use this
setting to prevent clients from seeing certain camera angles. Using the VB Administration
Tools is a convenient way to set the view restrictions (→ P.4-12).
“Upper value, Lower value, Left value, Right value”
Sets the extent of the field of view provided to users. (Specify settings so that the upper
value is greater than the lower value and the left value is less than the right value.)
“Telephoto, Wide-angle”
Sets the zoom angles provided to users. (Specify settings so that the telephoto setting is
less than or equal to the wide-angle setting.)
5 “Wide Converter”
When you have attached a wide converter to the camera, be sure to select “Used”. This setting
is only available for the VB-C50i.
* When the Wide Converter is set to "Used", the infrared light cannot be used.
Setting Camera Control, Image Size and Quality (Camera and Video)
+90°
–90°
–30°
+100°
+170°
+10°
–170°
–100°
“Pan”
Sets the pan position of the camera.
“Tilt”
Sets the tilt position of the camera.
“Zoom”
Sets the value for the camera’s angle of zoom.
“Brightness”
Sets the target value for the camera’s auto exposure feature. Select “Brighter” if the picture
is too dark due to backlight or other factors.
“Return to Home Position when nobody has a control privilege”
The camera is moved to its home position if there is no request for a control privilege.