Filter
Top Products
241
APPENDIX
Other
The wrong date and time are
displayed.
The date and time setting is off. Set the correct date and time (page 181).
The messages on the display
are in the wrong language.
The wrong display language is selected. Change the display language setting (page 185).
I can’t transfer images over a
USB connection.
1) The USB cable may not be connected securely. Check all connections.
2) USB driver may not be installed. Install the USB driver (page 203).
3) The USB driver may have been installed incorrectly. Reinstall the USB driver correctly (page 203).
4) The wrong USB communication protocol may be selected. Select the correct USB communication
protocol in accordance with the type of device you are connecting (page 187).
5) If the camera is not turned on, turn it on.
Display language setting
screen appears when the
camera is turned on.
1) You did not configure initial settings after purchasing the camera or the battery may have been left with
a dead battery. Check the camera setup (pages 11, 185).
2) The may be a problem with the camera’s built-in memory management area. If this is the case, perform
the reset operation to initialize the camera’s setup (page 133). After that, configure each setting. If the
language selection screen does not re-appear when you turn the camera on, it means that the camera’s
built-in memory management area has been restored.
If the same message appears after you turn power back on, contact your retailer or a CASIO service
center.
Problem Possible Causes and Action