Fujitsu FI-6140Z Photo Scanner User Manual


 
Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
107
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
Configuring the
Scan Settings
How to Use the
Operator Panel
4 Press the [Function] button and confirm that the function
number is flashing faster, and then either press the [Scan/
Stop] button or perform a scan from the computer.
From this point, note that the flashing speed of the Function Number
Display switches between "slow" Q "fast" every time you press the
[Function] button. When the flashing speed is fast, the scanner
operates in each mode as follows:
z Manual mode (Bypass by front panel button)
Scans the next sheet without multifeed detection, and from the
second sheet, multifeeds are detected based on the setting
configured in the scanner driver or the Software Operation Panel.
z Auto mode 1 (Bypass by combination of length and position)
Memorizes the length and location of the paper attachment that
was detected as multifeed, and continues scanning. When a paper
attachment of a similar pattern is detected, multifeed detection is
automatically suppressed. (*1)(*2)
z Auto mode 2 (Bypass by length)
Memorizes the length of the longest paper attachment that was
detected as multifeed, and continues scanning. When a paper
attachment of the same length or shorter is detected, multifeed
detection is automatically suppressed. (*1)(*2)
*1: 32 pages (up to 4 attachments per page) worth of overlap
patterns can be memorized in this mode. When it exceeds this
limit, the first pattern that was memorized is erased from the
memory.
*2: To erase the memorized overlap patterns and the longest
overlap length, hold down the [Function] button for more than 5
seconds while the function number is flashing. The Function
Number Display will then display "". This allows you to erase
multifeed patterns and the longest overlap length that were not
supposed to be memorized. Be careful with this operation
because all memorized patterns will be erased.
Do not hold down the [Function] button for more than 5
seconds when switching the flashing speed, because it
may erase the memorized multifeed patterns.