Filter
Top Products
Chapter 7 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
123
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
7 Attach the shaft.
1 Insert the right end of the shaft into the slot, and lower the other
end gradually.
2 Rotate the bushing to lock the shaft.
3 Close the sheet guide. Make sure that both ends of the sheet
guide are locked firmly.
8 Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 24).
9 Attach the ADF paper chute.
Insert the tabs into the slots on the back of the scanner, and tilt the
ADF paper chute backwards until it locks in place.
10 Reset the consumable counter.
Start up the Software Operation Panel and reset the counter.
For details, refer to "Resetting the counters" (page 167).
Confirm that the pick roller is installed properly.
Otherwise, it may cause feeding errors such as paper
jams.
Shaft
Bushing
Shaft
Be careful not to have your fingers caught
when the ADF closes.
ADF paper chute
Tab
Side guide
1
2