Fujitsu FI-6140Z Photo Scanner User Manual


 
Chapter 4 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
64
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Configuring the
Scan Settings
The operator panel consists of the Function Number Display,
buttons, and LED indicator.
Names and Functions
4.1 Operator Panel
Check
Function
Send to
Scan
/Stop
Power
LED indicator
Lights in orange when an error occurs.
Flashes when the ADF is open.
Function Number Display
Indicates the status of the scanner.
Switches off when the scanner enters power saving mode.
[Send to] button (*1)
Launches the linked application software.
Clears the displayed error indication.
Pauses the scan. (*2)
[Scan/Stop] button (*1)
Launches the linked application software.
Clears the displayed error indication.
Cancels or resumes the scan.
[Power] Button
Turns the power on/off.
Lights in green when the scanner is turned on.
[Function] button
Switches the number (1 to 9/C) assigned to the application
launched by the [Send to] button.
*1: For details about how to scan by pressing the [Scan/Stop] or
[Send to] button, refer to the TWAIN driver Help (included in the
Setup DVD-ROM) or "Using a Button on the Scanner to Start
Scanning" (page 101).
*2: When using TWAIN driver, pressing the [Send to] button during
scanning will pause the scan after that document is scanned.
When using ISIS driver/Kofax VRS/ScanSnap mode, pressing the
[Send to] button during scanning will cancel the scan after that
document is scanned.
Do not use the operator panel while the Software Operation
Panel is running.