Filter
Top Products
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
188
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Method of Turning the Scanner ON/OFF
[Power SW Control]
The method by which the scanner is powered on/off can be
specified from one of the following:
z Press the [Power] button on the operator panel
z Unplug the power cable then plug it back in
z Have the scanner turn on/off in sync with the computer's power
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 153).
2 From the listing on the left, select [Device Setting 2] J
[Power SW Control].
3 Select one of the following:
9.8 Settings Related to Power ON/OFF
[Enable power switch] : Press the [Power] button on the operator
panel.
[Disable power switch] : Unplug the power cable then plug it back
in.
[Enable USB power
feeding]
: Have the scanner turn ON/OFF in sync
with the computer's power.
Some types of computers and USB hubs keep supplying
power to the USB bus even after the computer is turned
off.
In that case, the [Enable USB power feeding] mode may
not work properly.