Fujitsu FI-6140Z Photo Scanner User Manual


 
Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
38
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
This section explains how to load documents in the ADF.
Preparation
1 If you are loading multiple sheets, check the documents.
1 Check if the documents to be loaded are of the same width or
different widths.
Ways to load documents differ depending on whether they are the
same width or not.
If the document width varies, refer to "Conditions for Mixed Batch
Scanning" (page 47) or "Documents with Different Widths" (page
69).
2 Check the number of sheets.
Up to 50 sheets can be loaded (with paper weight of 80 g/m² [20 lb]
and thickness of the document stack under 5 mm).
For details, refer to "Loading Capacity" (page 44).
2 Fan the documents.
1 Grab a stack of documents, which should be 5 mm or less.
2 Hold both ends of the documents and fan them a few times.
3 Rotate the documents by 90 degrees and fan them in the same
manner.
4 Perform steps 1 to 3 for all documents.
5 Align the edges of the documents.
2.1 Loading Documents in the ADF
For details about the paper size and quality required for normal
operations, refer to "2.3 Documents for Scanning (ADF)" (page
41).
For more details about how to fan documents, refer to the
Error Recovery Guide.
The Error Recovery Guide is included in the Setup DVD-
ROM. For details about installation, refer to "Installing the
Software" in Getting Started.