Fujitsu FI-6140Z Photo Scanner User Manual


 
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
186
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Waiting Time in Manual Feed Mode
[Manual-feed timeout]
When you scan by manually loading one sheet at a time, you
can specify the waiting time (interval) for loading the next
document in the ADF paper chute. This enables continuous
scanning as long as you load a document within the set time.
If not, the scan is finished automatically and manual feeding
will be canceled. Note that you can also press the [Send to]
button on the operator panel to cancel manual feeding.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 153).
2 From the listing on the left, select [Device Setting 2] J
[Manual-feed timeout].
3 Specify whether to enable or disable [Manual-feed
timeout].
If you selected [Enable], then also specify the time in [Paper-out
detection time].
9.7 Settings Related to Waiting Time
When [Manual-feed timeout] is enabled, the scanner will
wait for the set time even if you start scanning with no
document in the ADF paper chute.