Fujitsu FI-6140Z Photo Scanner User Manual


 
Chapter 7 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
122
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
3 Lift the bushing first, then pull out the shaft.
5 Remove the pick roller from its shaft.
Pull out the shaft as you lift the retaining clip.
6 Attach a new pick roller on the shaft.
Insert the protrusion on the shaft into the slot.
Be careful not to touch the gear near the bushing on the
shaft as it contains grease.
Bushing
Shaft
Shaft
Retaining clip
Pick roller
Lifting the retaining clip with your fingernail may hurt or
damage your fingernail.
Use a paper clip or something alike if you have trouble
lifting it up.
Confirm that the pick roller is installed properly.
Otherwise, it may cause feeding errors such as paper
jams.
Make sure to insert the pick roller until it locks in place.
1
2
Shaft
Pick roller
Protrusion
Slot