Fujitsu FI-6140Z Photo Scanner User Manual


 
Contents
Index
Chapter 2 How to Load Documents
Appendix
Glossary
Introduction
TOP
39
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
How to Load
Documents
How to Load Documents
1 Pull out the chute extensions according to the length of
the document.
For details, refer to "1.6 Setting Up the ADF Paper Chute" (page 26).
2 Lift the stacker and stacker extension according to the
length of the document.
For details, refer to "1.7 Setting Up the Stacker" (page 27).
3 Load the document face-down in the ADF paper chute.
4 Adjust the side guides to the width of the document.
Do not leave space between the side guides and the document.
Otherwise, the document may be fed skewed.
5 Start up an application for scanning and perform a scan.
For details about the scanning procedure in ScandAll PRO, refer to
"ScandAll PRO V2.0 User’s Guide".
Remove all paper clips and staples. Reduce the number
of sheets if a multifeed or pick error occurs.
Side guide