Filter
Top Products
Chapter 5 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
90
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
Configuring the
Scan Settings
How to Use the
Operator Panel
Feeding Documents Manually in the ADF
Documents can also be loaded manually one sheet at a time
in the ADF.
Normally, in automatic feeding, the scanner stops scanning
once all the documents loaded in the ADF paper chute have
been scanned.
In manual feeding, the scanner waits for the next document to
be loaded within a specified time. Scanning will continue as
long as another document is loaded within the set time, and
stops if no document is loaded.
By using this method, you can perform scanning as you check
the documents one by one.
Manual feeding is effective in the following cases.
z To scan as you check the contents of each sheet.
z To scan documents that cause multifeed or paper jam when loaded
together in the same batch.
z To continue scanning documents such as magazine/newspaper
clippings that cannot be loaded together.
1 Enable manual feeding in the Software Operation Panel.
For details, refer to "Waiting Time in Manual Feed Mode [Manual-feed
timeout]" (page 186).
2 Load a document in the ADF paper chute.
For details, refer to "Chapter 2 How to Load Documents" (page 37).
3 Scan the document by selecting the [Scan] menu J
[Scan] in ScandAll PRO.
D After the document is scanned, the rollers inside the ADF keep
rotating, waiting for the next document to be loaded for the time
specified in the Software Operation Panel.
4 Load the next document in the ADF paper chute.
D The document is scanned.
5 Repeat step 4 until all documents are scanned.
D Scanning will stop if no document is loaded within the set time.
z Pressing the [Send to] button on the operator panel will
stop the scan immediately.
z When [Manual-feed timeout] is enabled, the scanner
will wait for the set time even if you start scanning with
no document in the ADF paper chute.
z When you use manual feeding frequently, replacement
cycle of the consumables may be shortened.