Fujitsu FI-6140Z Photo Scanner User Manual


 
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
182
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Specifying the Area to Detect Multifeed
[Document check area specification for Multifeed
Detection]
The following setting is only available when you specified
[Check Overlapping (Ultrasonic)] or [Check Overlapping and
Length].
1 From the listing on the left, select [Device Setting 2] J
[Document check area specification for Multifeed
Detection].
Select the [Selected range] check box in the dialog box.
2 Specify the detection range.
Range Description
Selected range Select the check box to specify the detection
range (colored in light blue) in the picture below.
Select the check box to enable the setting in this
dialog box. Clear the check box to disable the
setting. Clearing this check box sets both start
and end positions to "0", making the whole
document to be detected for multifeeds.
The above condition applies when the document
is set to the center of the pick roller width.
Disable
(Middle)
Does not detect multifeeds for the selected area.
Enable
(Middle)
Detects multifeeds for the selected area.
Start
(Middle)
Displays the start position of the detection by the
length from the leading edge of the document.
Range: 0 to 510 mm, in 2 mm increments,
Start<End
End
(Middle)
Displays the end position of the detection by the
length from the leading edge of the document.
Range: 0 to 510 mm, in 2 mm increments,
Start<End
35
Middle
Range
Document
Feed direction
Unit: mm