Filter
Top Products
144
IMPORTANT
• Even when hard disk drive protection is enabled, mishandling the camera can
result in damage to the hard disk drive and/or the loss of saved data. Hard disk
drive protection does not guarantee the safety of the hard disk drive or the data
stored on it.
• If the camera detects that it has been dropped and stops access to the hard disk
drive, the “HARD DISK DRIVE CANNOT BE ACCESSED” message appears.
Turn the camera off and then on again.
• If the camera detects that it has been dropped during video recording and stops
access to the hard disk drive, the video file may be created incorrectly and you
may not be able to play it back. In this event, you should erase the video.
Resetting the System
This option returns the camera settings to the values specified at the time of purchase
(factory default). Note that this does not reset the settings for Drive & Album, the white
balance presets, the LAN settings, or the video output, language and date and time
settings.
1
From the setup menu, use the jog dial to select [SYSTEM]
and press the OK button.
The system menu appears.
2
Use the jog dial to select [RESET] and press the OK
button.
A confirmation message appears.
3
Use the jog dial to select [YES] and press the OK button.
When the reset is completed, the system menu
reappears.
RESET
CANCEL
RESET
ALL SETTINGS WILL BE
RESTORED
TO THEIR DEFAULTS.
YES NO