Filter
Top Products
Appendix
183
Troubleshooting
If an error or fault occurs, first check the error message displayed on the screen (
p.195) and the status of the LEDs ( p.25). Then refer to the information given below.
Problem
Cause Solution Page
Power/Preparation
I can’t charge
the battery.
The battery is not loaded in the
correct direction.
Reload the battery correctly.
28
The AC adapter is not
connected.
Connect the AC adapter.
30
The camera is not set in the
cradle properly.
Set the camera in the cradle
correctly.
30
The camera is turned on. Turn the camera off. 34
The camera or battery is
overheated.
Allow the camera or battery to
cool fully before charging.
30
The camera
won’t turn on.
The battery is not loaded in the
correct direction, or the AC
adapter is not connected.
Reload the battery correctly.
Connect the AC adapter.
28
30
The battery is out of charge. Charge the battery. 30
The battery has reached the
end of its service life.
Replace it with a new battery.
28
The camera
runs out of
power too
quickly.
The battery is out of charge. Charge the battery. 30
The terminals are soiled. Wipe the terminals on the
battery and in the camera with a
clean, dry cloth.
32
The battery has reached the
end of its service life.
Replace it with a new battery.
28
The camera
suddenly lost
power.
The Auto power off function was
activated.
Turn the camera back on.
Change the Auto power off
settings.
34
139
Auto power off
does not work.
Auto play is running. Stop Auto play. 111
You are connected to a DVD
recorder with DVR, computer,
or printer.
Auto power off is not available
when connected to a DVD
recorder with DVR, computer,
or printer.
139
The camera is in LAN mode. Change the mode. 26
The camera is connected to a
printer with PictBridge.
Exit PictBridge.
123