Filter
Top Products
130 en | Troubleshooting AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
No connection
established, no
image transmission.
The unit's
configuration.
Check all configuration
parameters.
Faulty installation. Check all cables, plugs,
contacts and connections.
Wrong IP address. Check the IP addresses
(terminal program).
Faulty data
transmission within
the LAN.
Check the data transmission
with ping.
The maximum number
of connections has
been reached.
Wait until there is a free
connection and then call the
sender again.
No audio
transmission to
remote station.
Hardware fault. Check that all connected
audio units are operating
correctly.
Faulty cable
connections.
Check all cables, plugs,
contacts and connections.
Incorrect
configuration.
Check audio parameters on
the Audio configuration and
LIVEPAGE Functions pages.
The audio voice
connection is already
in use by another
receiver.
Wait until the connection is
free and then call the sender
again.
The unit does not
report an alarm.
Alarm source is not
selected.
Select possible alarm sources
on the Alarm Inputs
configuration page.
No alarm response
specified.
Specify the desired alarm
response on the Alarm
Connections configuration
page, change the IP address if
necessary.
Malfunction Possible causes Recommended solution