Filter
Top Products
66 en | Preparing the Wiring AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
8.2.2 Power Connections to Outdoor Cameras
Figure 8.2 Power Cable
To connect the power to outdoor models:
1. Locate the cable assembly with a three (3) pin mating
connector on one end and the red and black flying leads on
the other end.
2. Connect one lead of the 24 VAC power source to the black
wire.
3. Connect the other lead of the 24 VAC power source to the
red wire.
4. Connect the green earth ground cable to a suitable
grounded conduit.
NOTICE! The AutoDome Easy II IP outdoor camera cannot be
powered via Power over Ethernet. You must supply a 24 VAC
power supply to the camera.
Ref. # Wire Color
1 24 VAC Red
2 24 VAC Black
3 User supplied Power Supply n/a
WARNING!
The camera unit accepts 24 VAC, 1.2 A power only. Do not
connect 120 V or 230 V to this camera.