Filter
Top Products
40 en | Installing a Wall Mount AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
5.1.4 Installing the Camera to the Mounting Plate
To install the camera to the mounting plate, do the following:
1. Attach the mounting plate (supplied with dome) to the
dome mounting cap with the three (3) screws supplied.
Figure 5.7 Attach Mounting Plate to Dome Cap
2. Route wires on side of mounting plate with crescent
shaped cut-out (Ref. #2 Figure 5.7).
3. Attach grounding wire from unit to the mounting cap (see
Figure 5.9).
4. Attach user supplied ground to junction box.
5. Connect the mating connectors with the flying leads to the
user supplied wiring (see the Section 8 Preparing the
Wiring, page 63 for wiring information).
1 Cable Hole (40 mm maximum; Crescent Shape
2 Mounting Screws for Dome Cap
4
0.0 mm
1.57 in.