Filter
Top Products
64 en | Preparing the Wiring AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
8.2 Connecting the Power
The AutoDome Easy II IP is available as an indoor or as an
outdoor model. Power to the camera in all indoor models is
supplied via a single power connector or via a Power over
Ethernet (PoE, IEEE 802.3af) connection using the existing CAT
5E Ethernet cable.
The outdoor models contain two 24 VAC isolated power
connectors, one for the camera (red and black wires) and one
for the heater (white/red and white/black wires).
Determining Power Connections
The table below summarizes the necessary power connections
for indoor and outdoor IP models. Use the table to identify the
necessary connections and for direction to the proper section.
NOTICE!
Use certified / Listed Class 2 power supply transformer only.
Model Connection Refer to
IP
Indoor 24 VAC Section 8.2.1 Power Connections to Indoor
Cameras, page 65
PoE to camera Section 8.3 Ethernet Connection (IP
models), page 67
Outdoor 24 VAC Section 8.2.2 Power Connections to Outdoor
Cameras, page 66
24 VAC to heater Section 8.2.3 Power Connections to Heater
(all outdoor models), page 67