Filter
Top Products
AutoDome Easy II IP Troubleshooting | en 131
Bosch Security Systems, Inc. Installation Manual F.01U.164.576 | 2.0 | 2010.03
Control of cameras
or other units is not
possible.
The cable connection
between the serial
interface and the
connected unit is not
correct.
Check all cable connections
and ensure all plugs are
properly fitted.
The interface
parameters do not
match those of the
other unit connected.
Make sure that the settings of
all units involved are
compatible.
The unit is not
operational after a
firmware upload.
Power failure during
programming by
firmware file.
Have the unit checked by
Customer Service and replace
if necessary.
Incorrect firmware file. Enter the IP address of the
unit followed by /main.htm in
your Web browser and repeat
the upload.
Placeholder with a
red cross instead of
the ActiveX
components.
JVM not installed on
your computer or not
activated.
Install Sun JVM from the
product CD.
Web browser
contains empty
fields.
Active proxy server in
network.
Create a rule in the local
computer's proxy settings to
exclude local IP addresses.
Malfunction Possible causes Recommended solution