Filter
Top Products
88 en | Configuring the AutoDome Easy II IP AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
With the user authorization level, you can operate the unit and
also control cameras, for example, but you cannot change the
configuration.
The lowest authorization level is live. It can only be used to
view the live video image and switch between the different live
image displays.
You can define and change a password for each authorization
level if you are logged in as service or if the unit is not
password protected.
Enter the password for the appropriate authorization level here.
Confirm password
In each case, enter the new password a second time to
eliminate typing mistakes.
12.2 Basic Mode: Date/Time
Device date/Device time/Device time zone
If there are multiple devices operating in your system or
network, it is important to synchronize their internal clocks. For
example, it is only possible to identify and correctly evaluate
simultaneous recordings when all units are operating on the
same time. If necessary, you can synchronize the unit with your
computer's system settings.
Click the Sync to PC button to copy your computer's
system time to the AutoDome Easy II IP.
NOTICE!
Proper password protection is only guaranteed when all higher
authorization levels are also protected with a password. If a live
password is assigned, for example, a service and a user
password must also be set. When assigning passwords, you
should therefore always start from the highest authorization
level, service, and use different passwords.
NOTICE!
A new password is only saved when you click the Set button.
You should therefore click the Set button immediately after
entering and confirming a password.