Filter
Top Products
AutoDome Easy II IP Installing a Surface Mount | en 29
Bosch Security Systems, Inc. Installation Manual F.01U.164.576 | 2.0 | 2010.03
12. Secure the mounting plate to the Surface Mount Junction
Box with the three (3) M4 – .7 x 8 Phillips pan head
machine screws.
Figure 4.8 Install the Mounting Plate
13. Skip to Section 4.1.4 Installing the Camera to the Mounting
Plate, page 29, to continue the installation.
4.1.4 Installing the Camera to the Mounting Plate
To install the camera to the mounting plate for a surface or
suspended ceiling, do the following (certain steps contain
additional information for outdoor installations):
1. Route wires on side of mounting plate with crescent
shaped cut-out (Ref. #2 Figure 4.3).
2. Attach grounding wire from unit to junction box.
3. Attach user supplied ground to junction box.
4. Connect the mating connectors with the flying leads to the
user supplied wiring (see Section 8 Preparing the Wiring,
page 63 for wiring information).
1 Junction Box Holes
2 Cable Hole (40 mm maximum); Crescent Shape
4
0 .0 mm
1.57 in.