Filter
Top Products
AutoDome Easy II IP Installing a Surface Mount | en 23
Bosch Security Systems, Inc. Installation Manual F.01U.164.576 | 2.0 | 2010.03
4.1.1 Additional Tools Required
– Appropriate straight slot screwdrivers
– No. 2 Phillips screwdriver
– Appropriate tool for cutting a hole in drywall or ceiling tile
(if applicable)
– 4 in. x 4 in. Junction box with 90 mm (3.54 in.) mount
holes (indoor installation)
– Four (4) M4 or #10 pan head screws of an appropriate
length to screw deep enough into the surface (outdoor
installation)
– One (1) ground
– T-10 Torx wrench
– VEZ-A2-JW or VEZ-A2-JC Surface Mount Junction Box,
required for an outdoor installation
– AutoDome Easy II Outdoor Camera, required for an
outdoor installation
4.1.2 Preparing the Surface Mount for an Indoor
Installation
The following instructions detail the preparation necessary to
prepare the surface and the steps to install a Surface Mount.
1. Determine a secure location for the surface mount dome.
Figure 4.1 Indoor Surface Mount Dimensions
ø
153.0
(6.02)
149.9
(5.88)
R50.6
(1.99)