Filter
Top Products
26 en | Installing a Surface Mount AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
3. Drill the four (4) holes in the installation location. Use a
minimum screw length of 10 mm (.39 in.).
4. Prepare the surface so that it can support a maximum load
of 11.33 kg (25 lbs).
5. Thread the four (4) 3.97 mm I.D. by Ø1.78 mm O-rings
(Item 3, Figure 4.6) onto the four (4) M4 or #10 user-
supplied pan head screws. The O-rings are supplied with
the AutoDome Easy II Outdoor Camera.
6. Ensure that the gasket is attached to the retaining ring. If
the gasket and the retaining ring are separate:
a. Locate the flat side of the gasket and the recessed
side of the retaining ring.
b. Thread the flat side of the gasket (item 1, below) onto
the recessed side of the retaining ring (item 2). The
illustration below shows a cross-section of the gasket
on the retaining ring.
CAUTION!
You must ensure that the gasket is attached to the retaining
ring as shown above to ensure an environmentally tight seal.