Filter
Top Products
38 en | Installing a Wall Mount AutoDome Easy II IP
F.01U.164.576 | 2.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.
6. Attach the mounting cap to the arm. Using the AutoDome
Easy II Outdoor Installation Kit, apply the following O-ring
and the retaining ring to the locations specified below:
Figure 5.5 O-ring and retaining ring for outdoor installation
a. Thread the 21.82 mm I.D. by Ø3.00 mm O-ring (item 1,
above) onto the lower arm threads.
b. Secure the retaining ring gasket (item 2, above) to the
dome cap with the three (3) M3 – .5 x 6 Phillips flat
head machine screws. Ensure that the side of the
retaining ring with the counter-sunk screw holes is
facing you.
c. Attach the dome cap to the arm mount.
7. Feed the wires through the hole in the surface, through the
wall mount flat gasket (item 1, Figure 5.6) and then
through the arm.
1 O-ring; 21.82 mm I.D. by Ø3.00 mm
2 Retaining ring with gasket
3 M3 – .5 x 6 Phillips flat head machine screws
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.