Filter
Top Products
AutoDome Easy II IP Installing a Surface Mount | en 27
Bosch Security Systems, Inc. Installation Manual F.01U.164.576 | 2.0 | 2010.03
7. Attach the retaining ring with gasket (item 2, below) to the
Surface Mount Junction Box. These parts are supplied with
the AutoDome Easy II Outdoor Camera. Ensure that the
side of the retaining ring with the counter-sunk screw
holes is facing you.
Figure 4.6 O-ring and retaining ring for outdoor installation
8. Determine the side of the Surface Mount Junction box in
which the external wires are to be routed and remove the
plug from the knockout.
9. Apply a 1/2-inch (15-mm) NPS fitting to the chosen
knockout. Ensure a water-tight fitting to maintain the IP
Environmental Protection Rating for the unit.
1 M3 – .5 x 6 Phillips flat head machine screws
(supplied with AutoDome Easy II Outdoor Camera)
2 Retaining ring with gasket
(supplied with AutoDome Easy II Outdoor Camera)
3 O-ring, 3.97 mm I.D. by Ø1.78 mm
(supplied with AutoDome Easy II Outdoor Camera)
4 User-supplied M4 or #10 pan head screws