Filter
Top Products
209
The time information obtained from GPS signals can be set in the
camera. The margin of error is approx. ±1 sec.
1
Select [Set up].
Check that [GPS] is set to [Enable].
Select [Set up], then press <0>.
2
Select [Auto time setting].
3
Select the desired setting.
Select [Auto update] or [Set now],
then press <0>.
[Auto update] updates the time when
the camera is turned on and a GPS
signal is received.
Setting Time from GPS on the Camera
If signals from at least five GPS satellites cannot be acquired, the time
cannot be auto updated. [Set now] will be grayed out and not selectable.
Even if [Set now] is selected, updating the time may not be possible due
to an unfavorable timing of the GPS signal acquisition.
When [Auto time setting] is set to [Auto update], the date or time
cannot be manually set with [Date/Time/Zone] under the [52] tab.
If you use Wireless Transmitter WFT-E7 (Ver. 2/sold separately) and do
not want to change the time after performing [Sync time between
cameras], set [Auto time setting] to [Disable] in step 2.