Filter
Top Products
93
S Selecting the AF Area and AF PointN
You can manually select the AF point or zone.
1
Press the <S> button.
X The AF points will be displayed in the
viewfinder.
In AF point expansion modes,
adjacent AF points will also be
displayed.
In the Zone AF mode, the selected
zone will be displayed.
2
Select an AF point.
The AF point selection will change in
the direction you tilt <9>. If you
press <9> straight down, the center
AF point (or center zone) will be
selected.
You can also select a horizontal AF
point by turning the <6> dial and
select a vertical AF point by turning
the <5> dial.
In the Zone AF mode, turning the
<6> or <5> dial will change the
zone in a looping sequence.
Selecting the AF Point Manually
When [24: Initial AF pt, AI Servo AF] is set to [Initial AF pt
selected] (p.127), you can use this method to manually select the AI
Servo’s AF starting position.
When you press the <S> button, the LCD panel displays the following:
• 65-point automatic selection AF, Zone AF, Large Zone AF: AF
• Single-point Spot AF, Single-point AF, and AF point expansion: SEL
(Center)/SEL AF (Off-center)
With [25: Manual AF pt. selec. pattern], you can set either [Stops at
AF area edges] or [Continuous] (p.129).