Filter
Top Products
Using the PDC-3000 with your PC 198
Changing operating preferences
Using the PDC software (TWAIN driver or PDC Direct) on
your computer, you can set the following PDC-3000 camera
and PDC software operating preferences. These preferences
remain unchanged until you set them again.
User name The user name stored in the camera is attached to
each picture. After a picture is taken, you can view the user
name to help identify the camera or photographer by using
the Get Info selection on the pop-up menu. (See Viewing
picture information on page 170.) Changing the user name
affects only pictures taken after the changes are made.
Pictures taken earlier and stored in the camera retain the user
name in effect when they were taken.
Default picture label The default picture label is attached to
each picture when it is taken. This label appears below each
thumbnail image in the Transfer Pictures tab to help
identification. It is also visible in the camera’s LCD panel.
After taking a picture, you can change its label from the
default to an individualized description by using the camera
controls (see the PDC-3000 User’s Guide) or by using the
PDC software (see Editing a picture label on page 173).
Changing the default picture label affects only pictures taken
after the changes are made. Pictures taken earlier and stored
Available options