46 PIXIS System Manual Version 2.C
1. After LightField opens, you should see an icon representing your camera in the
Available Devices area. In the figure above, the camera is a PIXIS:512B
eXcelon
®
.
2. Drag the icon into the Experiment Devices area.
Figure 14. Experiment Devices Area
3. Note that the Experiment Settings stack on the left now displays several
expanders. Because this is a new experiment, the default settings for the camera
will be active. The Status bar (at the bottom of the window) displays an icon for
temperature status.
Temperature status reports the current temperature and whether the set
temperature has been reached. Clicking on the icon, opens the Sensor expander
which is where the set temperature can be changed.
Confirming the Setup
1. Click on the View tab, just above Experiment Devices, to change to the display
area.
2. Wait until the camera locks at its default temperature.