Filter
Top Products
82 PIXIS System Manual Version 2.C
Custom Timing
Notes:
1. This mode is standard with LightField for full frame CCD cameras.
2. This option is fully supported by WinX Version 2.5.18.1 (and higher).
3. This option is not supported by WinX for 5 MHz systems..
In LightField, Custom Timing is accessed via the Custom Sensor button on the
Sensor expander. In the Custom Timing panel, you can select from among the listed
vertical shift rate choices (see Figure 48). Vertical shift rate is the time required to shift
one row into the serial register. The smaller the value, the faster charge will be shifted up
one row at a time toward the serial register. In WinX, if the Custom Timing option is
present and selected, the equivalent function is located on the Custom Timing tab on
the Hardware Setup dialog (see Figure 49).
Figure 48. LightField: Custom Timing
Figure 49. WinX: Vertical Shift