IBM 21Y Security Camera User Manual

128 Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,
6. Remove the hard disk drive cage (see “Installing a hard
disk drive in bays E, F, or G” on page 53).
7. Remove the adapter cards and place them on a static-
protected surface (see “Working with adapters” on
page 45).
8. Remove the memory cards and place them on a static-
protected surface (see “Installing memory-module kits”
on page 54).
9. Remove the voltage regulator module (see 9b on page
10. Detach all cables.
11. Remove any heatsinks:
Note: A thermal material is used between the heatsink
and the processor. This material when heated
and cooled causes the heatsink to adhere to the
processor. Some force may be required to
remove the heatsink.
a. Press the handle of the heatsink clip down and
toward the back until it releases, and lift it up and
off the heatsink.
b. Firmly grasp heat sink and pull upward.
Attention: Do not use excessive force or tools to
remove the heatsink.
c. Discard the used heatsink.
12. Remove all microprocessors and/or terminator card:
a. Lift the release lever.
b. Gently pull the microprocessor or terminator card
and place it in a static-protected location.
13. Remove the planar screws.
14. Lift the planar out of the server.