JVC GY-DV550U Camcorder User Manual


 
9. TIME CODE OPERATION
63
MENU
OVER
OVER
LIGHT
ON
OFF
COUNTER
CTL
TC
UB
RESET
OPERATE/WARNING
MONITOR
SELECT
E
REV FWD
FBATT
H
HM
MSF
REMAIN
AUD LOCK
32k
CH 1
CH 2
48k
PB NDF
AUTO OFF DEW
L iRFSERVO
HOLD
SP
40 30 20 10 0
dB
CH-1
MIX
CH-2
WIDE
SLAVE
AUDIO SELECT
CONTINUE
MANUAL
AUTO
INT
EXT
AUX
GROUP ITEM SELECT DATA SET
HOLD SHIFT ADVANCE PRESET
CAM
CH-1 CH-2 CH-1 CH-2
REAR
FRONT
AUDIO INPUT
CH-1
SEE
INSTR-
UCTION
MANUAL
CH-2
AUDIO
LEVEL
VTR SELECT
VTR INPUT
PARA
REC
FREE
PRST
REGEN
TC GENE.
MENU
LITHIUM BATT.
4.
SHIFT button
6.
PRESET
button
3.
ADVANCE
button
2.
HOLD button
H M S F
HOLD
H M S F
HOLD
H M S F
HOLD
H M S F
HOLD
TIME CODE PRESETTING PROCEDURE
1.
Display the time code on the counter display.
Set the COUNTER switch to "TC".
Time code up to 23 hrs. 59 min. 59 sec. 29 frames can be
preset.
2.
Place the time code generator in preset mode.
Press the HOLD button.
The "HOLD" indicator lights on the display to indicate
the preset mode. The first digit of the counter display
blinks.
3.
Set the value of the blinking digit.
Press the ADVANCE button.
The value of the blinking digit changes.
4.
Change the blinking digit.
Press the SHIFT button.
The blinking digit changes.
5.
Set the desired value for all digits.
Repeat steps
3.
and
4.
for each digit.
6.
Preset the set data in the memory.
Press the PRESET button.
The set data is saved as the time code generator value.
Following the above operation, the "HOLD" indicator
disappears from the display, the counter stops blinking
and the time code is preset.
If the REC/FREE switch is set to FREE, the time code
starts to run.
If you preset a wrong time code, perform steps
2
.
3
.
4
.
5.
and
6.
again.
PRESETTING USER'S BIT DATA
Display user's bit data on the counter display and perform
the same procedure as the time code presetting procedure.
The user's bit can be specified using numerals or alphabetic
letters from 0 to F for each digit.
Pressing the RESET button in the preset mode resets
the time code or user's bit data to 00 00 00 00.
If you press the HOLD button by mistake, press the HOLD
button once more to return to the previous display.
Do not set F to all users bit, or the data can not be read.
Note:
RESET button
9-2 Presetting and Recording of Time Code (Cont’d)