Filter
Top Products
105
Item Description
G ND Filter Position
Displays the current ND filter position.
No display : [ND FILTER] is set to AOFFB
ND1/4 : [ND FILTER] is set to A1/4B
ND1/16 : [ND FILTER] is set to A1/16B
Memo :
●
You can turn ON/OFF the display using [Filter] of [Status Display] in the [LCD/VF] menu.
(
A
Page 90)
H Remaining Space on
External Device
Displays the remaining recording time of the external device (0 to 999). When the remaining time is running out,
this is indicated in red (value + unit of measurement) as a warning to the user.
Memo :
● Only warnings are displayed in the STATUS 0 and STATUS 4 screens.
I Operation of External
Device
Displays the operating status of the connected external device. For details, refer to the instruction manual of the
corresponding external device.
Memo :
● Only warnings are displayed in the STATUS 0 and STATUS 4 screens.
J Time Code (TC)/
User’s Bit (UB)
Displays the time code (hour : minute : second : frame) or user’s bit data.
Memo :
●
You can turn ON/OFF the display using [TC/UB] of [Status Display] in the [LCD/VF] menu.
(
A
Page 91)
●
You can select whether to display the time code or user’s bit using the [TC DISPLAY] switch on the inner panel of
the LCD monitor.
K Synchronization with
External Time Code
Generator
This item is valid when [TCG Source] in the [TC/UB] menu is set to AExternalB.
Lights up : When the built-in time code generator is synchronized with the time code that is input to the
[TC IN] terminal.
Light goes out : When the signal is not synchronized, or when there is no time code input to the [TC IN]
terminal.
00:00:00:00
FF EE DD 20
Colon (:) for non-drop frames
Dot (.) for drop frames
Example : Time Code:
User’s Bit :