Filter
Top Products
135
Tally Lamps
The tally lamps start blinking when the remaining space on the SDHC card is running out during recording, or when the battery
power is running low.
Alarm Tone
Alarm tone is output from the monitor speaker and [PHONES] terminal when the battery level is low.
Alarm tone is output from the monitor speaker and [PHONES] terminal when the SDHC card is full. (Camera mode only)
Alarm tone is also output when an error occurs in the camera recorder.
Memo :
● [Alarm Level] in the [Others] menu can be used to specify whether alarm tone is to be output, as well as the volume level.
(A Page 93)
● Alarm tone is not output during recording.
Error Display
Status Action
Status Screen
Menu Screen
Thumbnail Screen
EXT-RECORDER
POWER ?
^ Power of the camera recorder is
turned off while the external device
connection is detected, and the same
connection cannot be detected
several seconds after power is turned
on again. (Error displays for about 7
seconds)
When making use of a connected external
device, turn on the power supply on the
connected device.
VIDEO FORMAT
INCORRECT
^ ● Video format of the file for Clip
Review is different from the
[Frame & Bit Rate] setting of the
camera recorder.
● IEEE1394 input video format is
different from the
[Camera Resolution] and
[Frame & Bit Rate] settings.
Set [Camera Resolution] and
[Frame & Bit Rate] correctly. (A Page 75)
● The video system of the camera
recorder is not compatible with the
IEEE1394 input signal.
Set [System Definition] in the
[Record Format] menu according to the
IEEE1394 signal. (A Page 75)
MEDIA FULL ^ ● [REC] button is pressed when the
media in use has no remaining
space.
● Remaining space ran out during
recording.
Replace the SDHC card with a new one.
FAN MAINTENANCE
REQUIRED
^ ● Usage time of the fan has
exceeded 9000 hours.
Check the fan and replace accordingly. For
more details, consult your nearest JVC
dealer.
Memo :
●
You can check the usage time of the fan in the
[Others] menu
B
[System Information]
B
[Fan Hour]. (
A
Page 95)
Blinking Mode Remaining Battery Power/SDHC Card Space
Blinks slowly
(once every second)
● Battery power is low
● Remaining recording time on SDHC card is less than 3 minutes
Blinks quickly
(4 times a second)
● SDHC card is full
● Error on the camera recorder