Filter
Top Products
131
The switch functions of the camera recorder can be
configured using the remote control unit.
* Remote control units supported : RM-LP25U, RM-LP55U,
RM-LP57U
1
Connect the remote control unit to the camera recorder.
Connect the remote cable of the remote control unit to the
[REMOTE] terminal on the terminal area of the camera
recorder.
Note :
● Turn off the power of the camera recorder when
connecting a remote control unit.
2 Turn on the power of the camera recorder.
3 Set the operate switch of the remote control unit to
ON.
Memo :
● For details on functions that can be operated using the
remote control unit, refer to [List of Remote Control Unit
Functions] (A Page 132).
Ⅵ Precautions for Using the Remote
Control Unit
● When the switches of the camera recorder and remote
control unit are operated at the same time, the switch
operation of the remote control unit takes priority over that
of the camera recorder.
● Focus and zoom operations cannot be performed using
the remote control unit.
● The shutter speed may vary slightly from the value
displayed on the camera recorder.
● When the frame rate in [Frame & Bit Rate] of the camera
recorder is set to A24pB, the shutter speed cannot be set
to A1/60B using the remote control unit. Even if the shutter
speed is set to A1/60B, the actual speed is A1/48B.
(A Page 75)
● When the camera recorder is in the Media mode, Auto
White does not function even when it is operated using
the remote control unit.
● When the H phase is set using a remote control unit, only
the H phase of the SD signal is activated.
● When setting the H Phase using a remote control unit,
any value beyond the setting range in the menu of the
camera recorder cannot be set. (A Page 96)
Remote Control Unit
Connection
RM-LP25U
[REMOTE] Terminal