Filter
Top Products
VI Basic Operations MICROSCOPE
6 Using the Microscope Control
- 149 -
Objective <Shows magnification and NA value of the objective >
Compatible only with Nikon 80i/90i microscopes that have motorized or intelligent nosepieces
attached.
1
）
The menu indicates the magnification and NA value of the current objective in the
nosepiece column
.
NOTE:
* Before using this function, you must set up the objective information from a
PC with the setup software. For more information, refer to the instruction
manual for your microscope.
* Use microscope control menu 1 to change objectives.
Stage position (Z axis) <Shows the address along vertical axis>
Compatible only with the Nikon 90i microscope.
1
）
The menu indicates the height of the current Z (focus) position (i.e., position along the Z
axis)
.
NOTE: Use microscope control menu 1 to adjust focus.
Stage position (X axis) <Shows address along lateral axis>
Compatible only with Nikon 90i microscopes connected to a motorized stage.
1
）
The menu indicates the current lateral stage position (position along the X axis) .
NOTE: Use microscope control menu 1 to adjust the stage position laterally.
Stage position (Y axis) <Shows the address along longitudinal axis>
Compatible only with Nikon 90i microscopes connected to a motorized stage.
1
）
The menu indicates the current longitudinal stage position (position along the Y axis)
.
NOTE: Use microscope control menu 1 to adjust the stage position longitudinally.