Filter
Top Products
VI Basic Operations SETUP
1 Preparations Before Photographing
- 29 -
Date:, Time:
Enter a date and time.
NOTE: If the DS-L1 remains turned off for extended periods, its internal timer may
slow down or stop. When the DS-L1 starts up, it displays the date and time
set in its timer (flashes for about 8 seconds). If you have shut off the DS-L1
for one week or longer, check the date and time shown on the DS-L1 when
you turn it back on.
Power Save Timer
If you leave the DS-L1 idle for a certain time, it will automatically switch to power-save
mode. You can set how long the DS-L1 will wait before switching to power-save mode.
Setting a value of “00” will disable the power-save function.
Pointer speed Low/Mid/High
Select the speed at which the mouse pointer moves across the screen when you move the
mouse.
E.Zoom Step
Select the magnification rate of the electronic zoom, at which rate the image is zoomed in
or out. (Two or more choices can be selected.)
Capture Function
Save to Card / Save to Server / Print
Select one of these functions to save to a CF card, to save to the FTP server, or to output
to a printer you want assigned to the CAPTURE button on the DS-L1 and the DS Remote
Controller DS-RC or to the CAPT. button on the menu. The CAPTURE button can be
assigned two or more functions at the same time.
External Out
This is an external interface output.
If you select ON, a strobe synchronizing signal is output from the EXTERNAL OUT
connector when capturing an image.
For normal use, we recommend selecting OFF. If you select ON, a time lag will occur in
external output with respect to the displayed image on the monitor.
Firmware Version
The number at the bottom-right indicates the firmware version.
The firmware version in the example shown is Ver = 220.0202.1717.040825. This is the
firmware Ver. 2.20.
300.****.****.** **** or later version is the firmware compatiple with 2M/5M cameras.