Filter
Top Products
VIII Troubleshooting
7 Microscope Control from the DS-L1
- 166 -
7
Microscope Control from the DS-L1
Symptom Corrective action
Unable to control
microscope functions.
(Or incorrect control
results.)
• Use only the Nikon 80i/90i/LV150A Microscope. This function cannot
be used with a microscope from a different company or other Nikon
microscope models.
• Turn on the power switch for the microscope.
• Wait until the microscope is ready for operation. It takes about 30
seconds for the microscope to be ready.
• Connect the USB cable securely between the DS-L1 to the digital
imaging head on the 80i or to the 90i microscope.
• Confirm that only one hub stage exists between the PC's USB port and
the DS-U1. We strongly recommend against using more than one hub.
• Use the USB cable supplied with the microscope to connect the
microscope to the DS-L1.
• Check whether the Nikon 80i or 90i microscope indicates an abnormal
state by buzzer or LED display. In the event of any abnormality on the
microscope, consult the instruction manual for your microscope.
Unable to display
microscope status.
(Or incorrect status
information is
displayed.)
• Make sure the microscope initial setting has been performed.
• Change the registration if the objective or filter has been changed.
8
Before Contacting Us
Please have the following information ready before contacting us:
• Conditions under which the problem occurs:
When does it occur? What signs indicate the problem? How often does it occur?
• Firmware Version
This number can be accessed from SETUP -> Additional at the bottom-right corner of the
screen.
• If computer-related problems occur
Operating system version and service pack (SP) number
Browser version
PC specifications (manufacturer, model, processor, memory capacity, etc.)
• Peripherals (USB mouse devices, CF card drives, etc.)
Manufacturers, model numbers
• If image problems occur
If possible, provide a sample image.