Filter
Top Products
VI Basic Operations MICROSCOPE
6 Using the Microscope Control
- 155 -
♦ List of autofocus messages
The following messages may be displayed while the microscope is autofocusing:
Message Content
Now Focusing Now autofocusing.
Do not alter the microscopy conditions.
Complete Autofocusing complete.
Comp. Low Contrast Sample lacking sufficient contrast for autofocusing.
Slight focal difference may take place in some conditions. Perform
manual focusing if this happens.
Warn. Exp.Over
Microscopy condition is too bright.
Focusing stops at the original position for the autofocus.
Use the autofocus function under following conditions set on the
DS-L1 (when the sample is nearly in focus).
Scene mode: BF
Exposure time: Under AE setting, the exposure time should come
within 1/120 to 1/350 (in 1.3 MP display mode)
when the sample is nearly in focus. (Adjust with
ND filters, etc.)
Warn. Exp.Under
Microscopy condition is too dark.
Focusing stops at the original position for the autofocus.
Use the autofocus function under following conditions set on the
DS-L1 (when the sample is nearly in focus).
Scene mode: BF
Exposure time: Under AE setting, the exposure time should come
within 1/120 to 1/350 (in 1.3 MP display mode)
when the sample is nearly in focus. (Adjust with
ND filters, etc.)
Error In the event of an error, one of the status codes (00–FF) will be
displayed on the screen.
(For more information, refer to the 90i Microscopy manual,
"Troubleshooting.")