TANDBERG Security Camera Security Camera User Manual


  Open as PDF
of 247
 
153
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Conguration
VCS
Conguration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Conguring the VCS as a Traversal Client
Conguring a Traversal Client Zone
VCS Conguration > Zones
•
.
You will be taken to the Zones page.
Click on the name of the zone you wish to
congure.
You will be taken to the Edit Zone page.
xConguration Zones Zon
•
e [1..200]
xConguration Zones Zon
•
e [1..200]
Traversal Client
Retry interval
Species the interval in seconds with which a
failed attempt to establish a connection to the
traversal server should be retried.
H.323 mode
Determines whether H.323 calls will be allowed
to and from this zone.
H.323 port
Species the port on the traversal server to be
used for H.323 rewall traversal calls.
H.323 protocol
Determines which of the two rewall traversal
protocols to use for calls to the traversal
server.
SIP mode
Determines whether SIP calls will be allowed to
and from this zone.
SIP port
Species the port on the traversal server to be
used for SIP calls from this VCS.
SIP transport
Determines which transport type will be used
for SIP calls to and from the traversal server.
Primary address
Species the IP address or FQDN of the
traversal server.
Alternate 1..5 Address
Species the IP addresses or FQDNs of any
alternates congured on the traversal server.
Remember to Save your changes.
Hop count
Species the hop count to be used when
querying this zone.
Authentication username
This eld displays the Authentication username
that has been congured on this VCS. The
Authentication username and password are
system-wide settings that are used for all
Traversal Client Zones. The Authentication
username cannot be edited directly from this
page but it is shown here for reference as it
is needed when conguring the corresponding
Traversal Server Zone.
To edit the Authentication username, click on
the Edit Authentication Username/Password
link. This will take you to the Authentication
page, where you can edit the settings under
the External Registration Credentials section.
 previous next