TANDBERG Security Camera Security Camera User Manual


  Open as PDF
of 247
 
155
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Conguration
VCS
Conguration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Conguring the VCS as a Traversal Server
Conguring a Traversal Server Zone
VCS Conguration > Zones
•
.
You will be taken to the Zones page.
Click on the name of the zone you wish to
congure.
You will be taken to the Edit Zones page.
xConguration Zones Zon
•
e
xConguration Zones Zone [1..200]
•
TraversalServer
H.323 mode
Determines whether H.323 calls will be allowed
to and from the traversal client.
H.323 port
Species the port on the VCS Expressway to
be used for H.323 connections from the client.
H.323 protocol
Determines which of the two rewall traversal
protocols will be used for calls through the
rewall, to and from the client. The same
protocol must be used by the client.
SIP mode
Determines whether SIP calls will be allowed to
and from the traversal client.
SIP port
Species the port on the VCS Expressway to
be used for SIP calls from the traversal client.
SIP transport
Determines which transport type will be used
for SIP calls to and from the traversal client.
Client authentication username
If the traversal client is a VCS, this must be the
VCS’s Authentication Username.
You must also add the client’s Authentication
username and password to the VCS’s
authentication database. To go directly to the
page where you can do this, click on the Add/
Edit Local Authentication Database link.
H.460.19 demux mode
On: allows use of the same two ports for media
for all calls from the traversal client.
Off: each call from the traversal client will use
a separate pair of ports for media.
TCP keep alive interval
Sets the interval (in seconds) with which the
traversal client will send a TCP probe to the
VCS once a call is established, in order to keep
the rewall’s NAT bindings open.
TCP retry count
Sets the number of times the traversal client
will attempt to send a TCP probe to the VCS
Expressway.
TCP retry interval
Sets the frequency (in seconds ) with which
the traversal client will send a TCP probe to the
VCS Expressway.
UDP keep alive interval
Sets the interval (in seconds) with which the
traversal client will send a UDP probe to the
VCS once a call is established, in order to keep
the rewall’s NAT bindings open.
UDP retry count
Sets the number of times the traversal client
will attempt to send a UDP probe to the VCS
Expressway.
UDP retry interval
Sets the interval (in seconds) with which the
traversal client will send a UDP probe to the
VCS Expressway.
 previous next